Industrial Fluorescence Probe
For fluorescence applications, a special reflection probe was developed with 12 excitation fibres of 200µm around a 600µm read fibre that takes the fluorescence signal back to the spectrometer.
A special reflector accessory FCR-FLTIP-IND is attached to the probe end to turn the 45º reflection probe into a fluorescence probe. The accessory prevents ambient light entering the probe and backscatters the excitation light to increase the fluorescence signal. The fluid channel path can be varied between 0 and 5mm.
Technical Details
|
Illumination fibres |
12x 200µm |
|
Detection fibres |
1x 600µm |
|
Wavelength range |
200-800nm (UV/VIS) or 350-2000nm (VIS/NIR) |
|
Connectors |
2x SMA905 |
|
Probe end |
Stainless Steel cylinder, 128mm long x 12.7mm (1/2”) diameter. The probe end contains a ca. 10x1mm sapphire window with anti-reflection coating. The probe tip is exchangeable and waterproof. |
|
Tubing |
The optical fibres are protected by a Silicon inner tube and chrome plated brass outer tubing. This tubing also provides stress relief. OD=5mm. As an option, a waterproof, stainless steel reinforced silicon tubing can be provided. |
|
Temperature |
-30°C - 100°C (high temperature versions on request) |
|
Bending |
Minimum bend radius: Short term (few seconds) 60mm, long term: 180mm |
Technical Drawing
Ordering Information
|
FCR-200/600-2-IND |
½” Industrial Reflection Probe for powders and turbid fluids, 7x200µm fibres, 2m length, SMA terminations |
|
FCR-FLTIP-IND |
Fluorescence reflector accessory for ½” FCR-UV200/600-2-IND probes |
