Reflection Probe Holders

RPH-1 Reflection Probe Holder

The RPH-1 Reflection probe holder is useful to fix an FCR standard reflection probe under an angle of 90 or 45 degrees, as mostly used for colour measurements. The 45 degree angle is used for diffuse reflection measurements.

The 90 degrees angle is used to measure specular reflection.

The holes have a 6.5 mm diameter and contain a setscrew to fix the probe in its position.

The RPH measures 60 x 30 x 30mm and is made of black anodised aluminum.

AFH-15 Angled Fibre Holder

The AFH-15 Angled Fibre Holder holder is useful to fix 1.5mm diameter ferrule terminated fibres (for example FC-UV200-2-1.5x40) or reflection probes (for example FCR- 7UV200-2-1.5x100) under 15º, 30º, 45º, 60º, 75º and 90º angles. In this way different reflection measurement setups can be made with multiple separate fibres for illumination and detection.

A total of 11 holes have each a 1.6mm diameter and contain a setscrew to fix the probe or fibre in its position. At the bottom is a 12mm half round of space free to enable reflection in all directions.

The AFH-15 is made of black anodised aluminum.

AFH Ocular

The AFH-Ocular was developed for reflection colour measurements on small spot diameters (<0.5mm). The ocular enables precise monitoring of the location of the measurement spot.

The holder is used for miniaturised reflection probes with 7 x 100µm fibres and 1mm outside diameter stainless steel tip (FCR-7UV100-2-1x25).

A black cover should be used during the measurement to cover the ocular from ambient light.

Ordering Information